(( Bracelets )) Loop / Unfinished Knot Bracelet
| Table of contents |
|---|
| 1 - Materials 2 - Step by Step 2.0 - Step 1 2.1 - Step 2 2.2 - Step 3 2.3 - Step 4 2.4 - Step 5 2.5 - Step 6 2.6 - Step 7 2.7 - Step 8 2.8 - Step 9 |
Materials
4 strings, all different colours, about 60 inches (150 cm) long, fold-over and make an over hand knot. Anchor it, in the method you usually use. Set up symmetrically.
Step by Step
Step 1
Make 4 chevrons.
Step 2
Make a backwards knot, but stop about 1/2 an inch from the top.
Then make another backwards knot and go all the way to the top.
You have make a loop!
Step 3
Make 2 backwards knots.
Step 4
Repeat steps 2-3, 3 more times.
Step 5
Make a forwards knot, but stop about 1/2 an inch from the top, then make another backward knot and go all the way to the top. You have made a loop.
Step 6
Make 2 forward knots.
Step 7
Repeat steps 5-6, 3 more times.
Step 8
Connect the two sides using the middle strings, and make a forward knot. It is okay since they are the same colour.
Step 9
Repeat steps 2-8 until it is at desired lenght, if wanted finish with 4 chevrons. Then do an overhand knot to finish.
Editors
The original author of this tutorial is milbug but it was also edited by Kestrel, Jeckle, Foz, ririttt and Alicat.
Uploaded photos (see all 3)
Comments