(( Bracelets )) Fishtail (Shoestring) Bracelet
| Table of contents |
|---|
| 1 - Introduction 2 - Materials 2.0 - Step 1 2.1 - Step 2 2.2 - Step 3 2.3 - Step 4 2.4 - Step 5 2.5 - Step 6 2.6 - Step 7 |
Introduction
Materials
You need 2 strings of a thicker material for example shoestring, packet string or Paracord. The stings needn't be much longer than your desired bracelet length.
You also need 2 coloured strings of any material for example waxed string, leather string, yarn, embroidery floss or Paracord. These strings have to be very long, therefore I didn't cut them until I finnished the bracelet.
[h1]Step by Step[/h2]
Step 1
Order your strings like the picture shows. The two coloured strings are left and right and the two thicker strings are in the middle.
Step 2
Put the right string above the right thick string and below the left thick string.
Step 3
Put the left string above the left thick string and below the right thick string.
Step 4
Repeat step 2.
Step 5
Repeat step 3.
Step 6
Pull tight.
Step 7
Repeat steps 2 and 3 and pull tight until your bracelet has the desired length.
Editors
The original author of this tutorial is Jazykat but it was also edited by k_marie, Alicat and Stefanie7.
Uploaded photos (see all 25)
Comments