(( Bracelets )) Chevron With Border
| Table of contents |
|---|
| 1 - Set Up 2 - Step by Step 2.0 - Step 1 2.1 - Step 2 2.2 - Step 3 2.3 - Step 4 2.4 - Step 5 2.5 - Step 6 2.6 - Step 7 2 - Videos |
Set Up
You set up your bracelet as you normally would in order to a chevron, however your outermost colour on the left and right side will be your border colour.
Step by Step
Step 1
Make your beginning loop using the method you prefer and get your colours in order having your outermost colour on both sides being your border colour
Step 2
Take your left most border colour and make a forward backward knot on the string next to it. Your border string should end up back on the outside.
Step 3
Continue on as you would making a chevron until you reach the middle of your arrangement
Step 4
Take your right most border colour and make a backward forward knot on the string next to it. Your border string should end up back on the outside.
Step 5
Continue on as you would make a chevron from the right side until you reach the middle of your arrangement.
Step 6
Tie your two middle strings together
Step 7
Repeat steps 2 - 6 until you reach your desired length
Videos
If you do not know how to do a normal chevron, take a look at this video:
Here is another good video that explains it well:
Editors
The original author of this tutorial is DesiCuppycakes but it was also edited by gracebri, RockePloeger, Foz, apprentice13 and Alicat.
Uploaded photos (see all 9)
Comments