(( Bracelets )) Basic Braid Bracelet
| Table of contents |
|---|
| 1 - Introduction 2 - Materials 3 - Step by Step 3.0 - Step 1 3.1 - Step 2 3.2 - Step 3 3.3 - Step 4 3 - Closure |
Introduction
This bracelet is very simple and easy and good for beginners to try. They are quite thin bracelets so it looks good if you make a whole bunch and wear them at the same time.
Materials
Cut 3 strings at least the length from your wrist to your shoulder. Tie them off at the top leaving about an inch.
Step by Step
Step 1
Lay out your strings -
A B C
Step 2
Put A over B so you have -
B A C
Step 3
Now put C over A so you have -
B C A
Step 4
Carry on putting the left one over the middle then the right one over the middle until you have a completed bracelet.
Also remember to not leave the threads spread apart so much in the bracelet. Pull the strings to make it tight but not too tight.
Closure
Once the bracelet is long enough, make 2 knots at the end about a centimetre apart. To wear, put the first knot through the hole that you just made!
Editors
The original author of this tutorial is NoodleCat but it was also edited by k_marie, Alicia434 and Alicat.
Uploaded photos (see all 35)
Comments