$976

was donated

(( Bracelets )) Vertical Wave Bracelet

Table of contents
1. Materials
2. Step by Step
    2.1. Step 1
    2.2. Step 2
    2.3. Step 3
    2.4. Step 4
    2.5. Step 5
    2.6. Step 6
    2.7. Step 7
    2.8. Step 8
3. Watch a Video Tutorial

Materials

2 different colours of weaving string. You will need a lot so it's best if you use skeins and put them on bobbins or something.
Background strings. 12 background strings makes a 2cm bracelet. You won't see them so you can use scrap strings. They should be about 70cm long each (will be folded).
A pair of scissors.
Something to hold the strings down while you work, like tape, a safety pin or a clipboard.

Step by Step

Step 1

Start your bracelet however you want. You can use buckles, braids, rope braids, etc.

Step 2

Set the two weaving strings to the left of the background strings. These will be called strings A and B. The order does not matter at all as long as you stick to it throughout the whole bracelet.

Step 3

With string A, make a row of forward knots until it is on the right side of the background strings.

Step 4

Pick up string B and make a row of forward knots until it's on the right side too.

Step 5

Still using string B, make a row of backward knots until you're back on the left side.

Step 6

Pick up string A again. Make a row of backward knots until you're on the left side. Strings A and B will both be back on the left of the background strings once you are finished.

Step 7

Repeat steps 3 to 6 until the bracelet is long enough.

Step 8

Finish the bracelet off using braids or attach ribbon clamps if you have any.

Watch a Video Tutorial

By Masha Knots

Editors

The original author of this tutorial is chibi_ragnarok, but it has also been edited by Alicat and Masha_Knots. The tutorial was last updated 12 days ago.

Your rating

Your browser does not accept javascript, sorry!

Uploaded photos (see all 87)

Click here to upload photos of your work!

Comments

Need JavaScript enabled to view this commenting tool.