$1911

was donated

(( Bracelets )) Vertical Wave Bracelet

Table of contents
1 - Materials
2 -
Step by Step
   2.0 -
Step 1
   2.1 -
Step 2
   2.2 -
Step 3
   2.3 -
Step 4
   2.4 -
Step 5
   2.5 -
Step 6
   2.6 -
Step 7
   2.7 -
Step 8
2 -
Watch a Video Tutorial


Materials


2 different colours of weaving string. You will need a lot so it's best if you use skeins and put them on bobbins or something.
Background strings. 12 background strings makes a 2cm bracelet. You won't see them so you can use scrap strings. They should be about 70cm long each (will be folded).
A pair of scissors.
Something to hold the strings down while you work, like tape, a safety pin or a clipboard.



Step by Step



Step 1


Start your bracelet however you want. You can use buckles, braids, rope braids, etc.



Step 2


Set the two weaving strings to the left of the background strings. These will be called strings A and B. The order does not matter at all as long as you stick to it throughout the whole bracelet.



Step 3


With string A, make a row of forward knots until it is on the right side of the background strings.



Step 4


Pick up string B and make a row of forward knots until it's on the right side too.



Step 5


Still using string B, make a row of backward knots until you're back on the left side.



Step 6


Pick up string A again. Make a row of backward knots until you're on the left side. Strings A and B will both be back on the left of the background strings once you are finished.



Step 7


Repeat steps 3 to 6 until the bracelet is long enough.



Step 8


Finish the bracelet off using braids or attach ribbon clamps if you have any.



Watch a Video Tutorial



By Masha Knots

Editors

The original author of this tutorial is chibi_ragnarok but it was also edited by Alicat and Masha_Knots.

Uploaded photos (see all 105)

Click here to upload photos of your work!

Comments